4/24/2023 0 Comments Raspberry pi 3 xscreensaver![]() ![]() Will try what happens when I remove them a bit later. Not sure what the other entries do, I just appended the lines to the existing entries. If your cronjob works for turning on / off the screen, then I guess you do not need to use the parameters to turn off the screen.įor Debain Stretch (screen always on): $ cat -profile -desktop -profile -display :0 -idle 3 -root s s -dpmsįor Debian Buster (screen off after 900 seconds): $ cat -profile -desktop -profile s s -dpms With lsb_release -ayou can find out which version you have. I guess you downloaded and installed an image with Debian, like fromĭebian Buster is the latest Debian version. The version on has a working xscreensaver but not xscreensaver-demo or xscreensaver-command. Sorry, but Debian buster and Debian stretch? HTH (my first post said in My MagicMirror screen keeps turning off: install xscreensaver and configure it to not kick in Built specifically for the new Pi 3, the Broadcom BCM2837 system-on-chip (SoC) includes four high-performance ARM Cortex-A53 processing cores running at 1.2GHz with 32kB Level 1 and 512kB Level 2 cache memory, a VideoCore IV graphics processor, and is linked to a 1GB LPDDR2 memory module on the rear of the board. PS.: Before I found this I also tried these solutions (which all failed to solve the problem A. I “just” add the three required lines to the config file: printf s s noblank" | sudo tee -a /etc/xdg/lxsession/LXDE-pi/autostart The config change can be applied in many ways (vi, nano etc) but I prefer this method (as it can be copy-pasted or be made part of a config-script). Method 1 This method uses a global list of autostart applications that applies to all user accounts. Right now I still see the screen after 16m (and counting…) Start by booting your Pi to the command prompt. Prefer blanking: yes allow exposures: yesĪfter fixing it the value gets set to ‘0’ Which can also be identified by the “timeout value” returned by this command. xset -display :0 s blank Turn the monitor to it's default state (black hopefully): xset -display :0 dpms force off Turn the monitor back on by hitting a key, moving the mouse, or using this command: xset -display :0 dpms force on Method 2: Turn off the HDMI port and back on. Without this change the screen goes black after 600s (10m) So this is just to help others with the same search that this still works on the current latest RPI OS bullseye: $ lsb_release -aĭescription: Raspbian GNU/Linux 11 (bullseye) But that’s to annoying, hence my need for a CLI based solutionįinally I found it in this thread (thank you !) I know I could just use RDP or VNC to access and thus make this change via a GUI. Raspberry Pi 3 Model B Plus Rev 1.3: Motherboard: N/A: CPU Information Name: ARM BCM2835: Topology: 1 Processor, 1 Core, 4 Threads: Base Frequency: 1.50 GHz: Cluster 1: 0 Cores: Memory Information Memory: 921 MB : Single-Core Performance. I am using the “Raspberry Pi Imager” tool (on Window$) to prepare a USB stick (or SD card) and hereafter configure everything via SSH. So I have also been searching a lot for an answer to this question and been wondering why it have been so difficult to find a CLI based solution to this task.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |